Towards the realization of large-scale Foley recording at SKYSQUARE
We have obtained additional licenses.
It's called a "rigging skills training course."
This license allows you to lift loads onto a crane.
This license will be essential for the various recordings we will be doing from now on.
▢You need a license to carry luggage
Use wire ropes to tie the load to the crane.
The act of hanging it on a crane.
There are separate licenses for this work, and in order to do this work
It will be a necessary technology.
▢After using various licenses, it is finally possible to use
By combining the small mobile crane license and the large type 1 license
Finally, you will be able to load the load onto the truck crane, move it around, and unload the load.
Receiving large-scale Foley materials and handling cranes used during recording, etc.
There are many different uses for this technology, and we plan to continue conducting various tests to ensure that it can be used to its full potential.
There are three exams (written exam, mass measurement exam, practical exam)
There are three exams in the rigging skills training course, and you can obtain the rigging skills training certificate by passing all of them.
In the academic section, you will learn not only the content of slinging, but also calculation methods, as the exams will cover mechanics and mass measurement.
Mass visual estimation tests involve estimating the size of an object and calculating its density based on the material it is made from to determine its weight.
Ultimately, this could result in the wrong load being hoisted when slinging, which could lead to the crane tipping over, so it is important to have a solid understanding.
In practical training, this is a signal to ensure safety when performing slinging.
The test also includes giving various signals at the right times.
During the practical session, I had to constantly look at the other students and the instructor's instructions and memorize what I was doing.
▢Crane operation and rigging must be done by multiple people.
It is preferable for multiple people to operate the crane and rig the equipment.
Nakajima and Takeda both obtained their licenses.
It's not impossible to do it alone,
In order to utilize the crane function of our excavator, the crane operator and the rigger must be separate persons.
In addition, it was necessary for our section manager, Takeda, to acquire knowledge of hazard prediction, so we had him take the test.
Both of them successfully obtained their licenses.
I think I'll move on to the next stage.
The driving school where I obtained my license is the following center.
Since it's located in Chiba Prefecture, I think it's easy to get to for people living in Tokyo.
Kobelco Driving School
Ichikawa Training Centerhttps ://www.kobelco-kyoshu.com/
Current licenses held
The licenses currently held by AZSTOKE are as follows.
Large vehicle type 1 license
Large special vehicle license
Towing license
Vehicle-mounted construction machinery (land leveling, etc.)
Vehicle-mounted construction machinery (newly dismantled)
Small Mobile Crane
Chainsaw (for felling trees, etc.)
Sling [NEW]
Comentarios